tinyriscv-openocd/tcl/board/tp-link_tl-mr3020.cfg

45 lines
1.7 KiB
INI

source [find target/atheros_ar9331.cfg]
proc ar9331_25mhz_pll_init {} {
mww 0xb8050008 0x00018004 ;# bypass PLL; AHB_POST_DIV - ratio 4
mww 0xb8050004 0x00000352 ;# 34000(ns)/40ns(25MHz) = 0x352 (850)
mww 0xb8050000 0x40818000 ;# Power down control for CPU PLL
;# OUTDIV | REFDIV | DIV_INT
mww 0xb8050010 0x001003e8 ;# CPU PLL Dither FRAC Register
;# (disabled?)
mww 0xb8050000 0x00818000 ;# Power on | OUTDIV | REFDIV | DIV_INT
mww 0xb8050008 0x00008000 ;# remove bypass;
;# AHB_POST_DIV - ratio 2
}
proc ar9331_ddr1_init {} {
mww 0xb8000000 0x7fbc8cd0 ;# DDR_CONFIG - lots of DRAM confs
mww 0xb8000004 0x9dd0e6a8 ;# DDR_CONFIG2 - more DRAM confs
mww 0xb8000010 0x8 ;# Forces a PRECHARGE ALL cycle
mww 0xb8000008 0x133 ;# mode reg: 0x133 - default
mww 0xb8000010 0x1 ;# Forces an MRS update cycl
mww 0xb800000c 0x2 ;# Extended mode register value.
;# default 0x2 - Reset to weak driver, DLL on
mww 0xb8000010 0x2 ;# Forces an EMRS update cycle
mww 0xb8000010 0x8 ;# Forces a PRECHARGE ALL cycle
mww 0xb8000008 0x33 ;# mode reg: remove some bit?
mww 0xb8000010 0x1 ;# Forces an MRS update cycl
mww 0xb8000014 0x4186 ;# enable refres: bit(14) - set refresh rate
mww 0xb800001c 0x8 ;# This register is used along with DQ Lane 0,
;# DQ[7:0], DQS_0
mww 0xb8000020 0x9 ;# This register is used along with DQ Lane 1,
;# DQ[15:8], DQS_1.
mww 0xb8000018 0xff ;# DDR read and capture bit mask.
;# Each bit represents a cycle of valid data.
}
$_TARGETNAME configure -event reset-init {
ar9331_25mhz_pll_init
sleep 1
ar9331_ddr1_init
}
set ram_boot_address 0xa0000000
$_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000