56 lines
1.7 KiB
INI
56 lines
1.7 KiB
INI
# Use RCLK. If RCLK is not available fall back to 500kHz.
|
|
#
|
|
# Depending on cabling you might be able to eek this up to 2000kHz.
|
|
jtag_rclk 500
|
|
|
|
if { [info exists CHIPNAME] } {
|
|
set _CHIPNAME $CHIPNAME
|
|
} else {
|
|
set _CHIPNAME lpc2148
|
|
}
|
|
|
|
if { [info exists ENDIAN] } {
|
|
set _ENDIAN $ENDIAN
|
|
} else {
|
|
set _ENDIAN little
|
|
}
|
|
|
|
if { [info exists CPUTAPID ] } {
|
|
set _CPUTAPID $CPUTAPID
|
|
} else {
|
|
set _CPUTAPID 0x4f1f0f0f
|
|
}
|
|
|
|
jtag_nsrst_delay 200
|
|
jtag_ntrst_delay 200
|
|
|
|
# NOTE!!! LPCs need reset pulled while RTCK is low. 0 to activate
|
|
# JTAG, power-on reset is not enough, i.e. you need to perform a
|
|
# reset before being able to talk to the LPC2148, attach is not possible.
|
|
|
|
reset_config trst_and_srst srst_pulls_trst
|
|
|
|
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
|
|
|
|
set _TARGETNAME $_CHIPNAME.cpu
|
|
target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
|
|
|
|
$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
|
|
|
|
$_TARGETNAME configure -event reset-init {
|
|
# Force target into ARM state
|
|
armv4_5 core_state arm
|
|
|
|
# Do not remap 0x0000-0x0020 to anything but the flash (i.e. select
|
|
# "User Flash Mode" where interrupt vectors are _not_ remapped,
|
|
# and reside in flash instead).
|
|
#
|
|
# See section 7.1 on page 32 ("Memory Mapping control register") in
|
|
# "UM10139: Volume 1: LPC214x User Manual", Rev. 02 -- 25 July 2006.
|
|
# http://www.standardics.nxp.com/support/documents/microcontrollers/pdf/user.manual.lpc2141.lpc2142.lpc2144.lpc2146.lpc2148.pdf
|
|
mwb 0xE01FC040 0x01
|
|
}
|
|
|
|
# flash bank lpc2000 <base> <size> 0 0 <target#> <variant> <clock> [calc_checksum]
|
|
flash bank lpc2000 0x0 0x7d000 0 0 $_TARGETNAME lpc2000_v2 14765 calc_checksum
|