tinyriscv-openocd/tcl/target/stm8s.cfg

85 lines
1.8 KiB
INI

# script for stm8s family
#
# stm8 devices support SWIM transports only.
#
transport select stlink_swim
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
set _CHIPNAME stm8s
}
# Work-area is a space in RAM used for flash programming
# By default use 1kB
if { [info exists WORKAREASIZE] } {
set _WORKAREASIZE $WORKAREASIZE
} else {
set _WORKAREASIZE 0x400
}
if { [info exists FLASHSTART] } {
set _FLASHSTART $FLASHSTART
} else {
set _FLASHSTART 0x8000
}
if { [info exists FLASHEND] } {
set _FLASHEND $FLASHEND
} else {
set _FLASHEND 0xffff
}
if { [info exists EEPROMSTART] } {
set _EEPROMSTART $EEPROMSTART
} else {
set _EEPROMSTART 0x4000
}
if { [info exists EEPROMEND] } {
set _EEPROMEND $EEPROMEND
} else {
set _EEPROMEND 0x43ff
}
if { [info exists OPTIONSTART] } {
set _OPTIONSTART $OPTIONSTART
} else {
set _OPTIONSTART 0x4800
}
if { [info exists OPTIONEND] } {
set _OPTIONEND $OPTIONEND
} else {
set _OPTIONEND 0x487f
}
if { [info exists BLOCKSIZE] } {
set _BLOCKSIZE $BLOCKSIZE
} else {
set _BLOCKSIZE 0x80
}
hla newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id 0
set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME stm8 -chain-position $_CHIPNAME.cpu
$_TARGETNAME configure -work-area-phys 0x0 -work-area-size $_WORKAREASIZE -work-area-backup 1
$_TARGETNAME configure -flashstart $_FLASHSTART -flashend $_FLASHEND -eepromstart $_EEPROMSTART -eepromend $_EEPROMEND
$_TARGETNAME configure -optionstart $_OPTIONSTART -optionend $_OPTIONEND -blocksize $_BLOCKSIZE
# Uncomment this line to enable interrupts while instruction step
#$_TARGETNAME configure -enable_step_irq
# The khz rate does not apply here, only slow <0> and fast <1>
adapter_khz 1
reset_config srst_only
# uncomment this line to connect under reset
#reset_config srst_nogate connect_assert_srst