tinyriscv-openocd/tcl/target/ar71xx.cfg

58 lines
1.9 KiB
INI

# Atheros AR71xx MIPS 24Kc SoC.
# tested on PB44 refererence board
adapter_nsrst_delay 100
jtag_ntrst_delay 100
reset_config trst_and_srst
set CHIPNAME ar71xx
jtag newtap $CHIPNAME cpu -irlen 5 -ircapture 0x1 -irmask 0x1f -expected-id 1
set TARGETNAME $CHIPNAME.cpu
target create $TARGETNAME mips_m4k -endian big -chain-position $TARGETNAME
$TARGETNAME configure -event reset-halt-post {
#setup PLL to lowest common denominator 300/300/150 setting
mww 0xb8050000 0x000f40a3 # reset val + CPU:3 DDR:3 AHB:0
mww 0xb8050000 0x800f40a3 # send to PLL
#next command will reset for PLL changes to take effect
mww 0xb8050008 3 # set reset_switch and clock_switch (resets SoC)
}
$TARGETNAME configure -event reset-init {
#complete pll initialization
mww 0xb8050000 0x800f0080 # set sw_update bit
mww 0xb8050008 0 # clear reset_switch bit
mww 0xb8050000 0x800f00e8 # clr pwrdwn & bypass
mww 0xb8050008 1 # set clock_switch bit
sleep 1 # wait for lock
# Setup DDR config and flash mapping
mww 0xb8000000 0xefbc8cd0 # DDR cfg cdl val (rst: 0x5bfc8d0)
mww 0xb8000004 0x8e7156a2 # DDR cfg2 cdl val (rst: 0x80d106a8)
mww 0xb8000010 8 # force precharge all banks
mww 0xb8000010 1 # force EMRS update cycle
mww 0xb800000c 0 # clr ext. mode register
mww 0xb8000010 2 # force auto refresh all banks
mww 0xb8000010 8 # force precharge all banks
mww 0xb8000008 0x31 # set DDR mode value CAS=3
mww 0xb8000010 1 # force EMRS update cycle
mww 0xb8000014 0x461b # DDR refresh value
mww 0xb8000018 0xffff # DDR Read Data This Cycle value (16bit: 0xffff)
mww 0xb800001c 0x7 # delay added to the DQS line (normal = 7)
mww 0xb8000020 0
mww 0xb8000024 0
mww 0xb8000028 0
}
# setup working area somewhere in RAM
$TARGETNAME configure -work-area-phys 0xa0600000 -work-area-size 0x20000
# serial SPI capable flash
# flash bank <driver> <base> <size> <chip_width> <bus_width>