tinyriscv-openocd/tcl/target/omap3530.cfg

62 lines
1.7 KiB
INI

# TI OMAP3530
# http://focus.ti.com/docs/prod/folders/print/omap3530.html
# Other OMAP3 chips remove DSP and/or the OpenGL support
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
set _CHIPNAME omap3530
}
# ICEpick-C ... used to route Cortex, DSP, and more not shown here
source [find target/icepick.cfg]
# Subsidiary TAP: C64x+ DSP ... must enable via ICEpick
jtag newtap $_CHIPNAME dsp -irlen 38 -ircapture 0x25 -irmask 0x3f -disable
# Subsidiary TAP: CoreSight Debug Access Port (DAP)
if { [info exists DAP_TAPID ] } {
set _DAP_TAPID $DAP_TAPID
} else {
set _DAP_TAPID 0x0b6d602f
}
jtag newtap $_CHIPNAME dap -irlen 4 -ircapture 0x1 -irmask 0xf \
-expected-id $_DAP_TAPID -disable
jtag configure $_CHIPNAME.dap -event tap-enable \
"icepick_c_tapenable $_CHIPNAME.jrc 3"
# Primary TAP: ICEpick-C (JTAG route controller) and boundary scan
if { [info exists JRC_TAPID ] } {
set _JRC_TAPID $JRC_TAPID
} else {
set _JRC_TAPID 0x0b7ae02f
}
jtag newtap $_CHIPNAME jrc -irlen 6 -ircapture 0x1 -irmask 0x3f \
-expected-id $_JRC_TAPID
jtag configure $_CHIPNAME.jrc -event post-reset "runtest 100"
# GDB target: Cortex-A8, using DAP
target create omap3.cpu cortex_a8 -chain-position $_CHIPNAME.dap
# FIXME much of this should be in reset event handlers
proc omap3_dbginit { } {
poll off
sleep 100
jtag tapenable omap3530.dap
targets
# General Cortex A8 debug initialisation
cortex_a8 dbginit
# Enable DBGU signal for OMAP353x
omap3.cpu mww 0x5401d030 0x00002000
poll on
}
set PRM_RSTCTRL 0x48307250
omap3.cpu configure -event reset-start "omap3.cpu mww $PRM_RSTCTRL 2"
omap3.cpu configure -event reset-assert-pre "omap3_dbginit"