tinyriscv-openocd/tcl/target/bluenrg-x.cfg

74 lines
1.7 KiB
INI

#
# bluenrg-1/2 devices support only SWD transports.
#
source [find target/swj-dp.tcl]
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
set _CHIPNAME bluenrg-1
}
set _ENDIAN little
# Work-area is a space in RAM used for flash programming
# By default use 24kB-256bytes
if { [info exists WORKAREASIZE] } {
set _WORKAREASIZE $WORKAREASIZE
} else {
set _WORKAREASIZE 0x5F00
}
adapter_khz 4000
if { [info exists CPUTAPID] } {
set _CPUTAPID $CPUTAPID
} else {
set _CPUTAPID 0x0bb11477
}
swj_newdap $_CHIPNAME cpu -expected-id $_CPUTAPID
set _TARGETNAME $_CHIPNAME.cpu
set WDOG_VALUE 0
set WDOG_VALUE_SET 0
target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME
$_TARGETNAME configure -work-area-phys 0x20000100 -work-area-size $_WORKAREASIZE -work-area-backup 0
# flash size will be probed
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME bluenrg-x 0 0 0 0 $_TARGETNAME
# In BlueNRG-X reset pin is actually a shutdown (power-off), so define reset as none
reset_config none
if {![using_hla]} {
# if srst is not fitted use SYSRESETREQ to
# perform a soft reset
cortex_m reset_config sysresetreq
}
$_TARGETNAME configure -event halted {
global WDOG_VALUE
global WDOG_VALUE_SET
# Stop watchdog during halt, if enabled
mem2array value 32 0x40700008 1
set WDOG_VALUE [expr ($value(0))]
if [expr ($value(0) & (1 << 1))] {
set WDOG_VALUE_SET 1
mww 0x40700008 [expr ($value(0) & 0xFFFFFFFD)]
}
}
$_TARGETNAME configure -event resumed {
global WDOG_VALUE
global WDOG_VALUE_SET
if [expr $WDOG_VALUE_SET] {
# Restore watchdog enable value after resume
mww 0x40700008 $WDOG_VALUE
set WDOG_VALUE_SET 0
}
}