tinyriscv-openocd/tcl/board/numato_mimas_a7.cfg

37 lines
1.2 KiB
INI

#
# Numato Mimas A7 - Artix 7 FPGA Board
#
# https://numato.com/product/mimas-a7-artix-7-fpga-development-board-with-ddr-sdram-and-gigabit-ethernet
#
# Note: Connect external DC power supply if programming a heavy design onto FPGA.
# Programming while powering via USB may lead to programming failure.
# Therefore, prefer external power supply.
interface ftdi
ftdi_device_desc "Mimas Artix 7 FPGA Module"
ftdi_vid_pid 0x2a19 0x1009
# channel 0 is for custom purpose by users (like uart, fifo etc)
# channel 1 is reserved for JTAG (by-default) or SPI (possible via changing solder jumpers)
ftdi_channel 1
ftdi_tdo_sample_edge falling
# FTDI Pin Layout
#
# +--------+-------+-------+-------+-------+-------+-------+-------+
# | DBUS7 | DBUS6 | DBUS5 | DBUS4 | DBUS3 | DBUS2 | DBUS1 | DBUS0 |
# +--------+-------+-------+-------+-------+-------+-------+-------+
# | PROG_B | OE_N | NC | NC | TMS | TDO | TDI | TCK |
# +--------+-------+-------+-------+-------+-------+-------+-------+
#
# OE_N is JTAG buffer output enable signal (active-low)
# PROG_B is not used, so left as input to FTDI.
#
ftdi_layout_init 0x0008 0x004b
reset_config none
adapter_khz 30000
source [find cpld/xilinx-xc7.cfg]
source [find cpld/jtagspi.cfg]