tcl/board: add DPTechnics DPT-Board-v1

it is Atheros AR9331 based IoT dev board.

Change-Id: I6fc3cdea1bef49c53045018ff5acfec4d5610ba6
Signed-off-by: Oleksij Rempel <linux@rempel-privat.de>
Reviewed-on: http://openocd.zylin.com/4424
Tested-by: jenkins
Reviewed-by: Paul Fertser <fercerpav@gmail.com>
bscan_tunnel
Oleksij Rempel 2018-02-19 17:00:17 +01:00 committed by Paul Fertser
parent bebdbe8b73
commit c1b8824d19
1 changed files with 32 additions and 0 deletions

View File

@ -0,0 +1,32 @@
# Product page:
# https://www.dptechnics.com/en/products/dpt-board-v1.html
#
# JTAG is a 5 pin array located close to main module in following order:
# 1. JTAG TCK
# 2. JTAG TDO
# 3. JTAG TDI
# 4. JTAG TMS
# 5. GND The GND is located near letter G of word JTAG on board.
#
# Two RST pins are connected to:
# 1. GND
# 2. GPIO11 this pin is located near letter R of word RST.
#
# To enable EJTAG mode, GPIO11 (RST[1]) pin should be pulled up. For example
# with 10K resistor connected to V3.3 pin.
#
# This board is powered from micro USB connector. No real reset pin or button, for
# example RESET_L is available.
source [find target/atheros_ar9331.cfg]
$_TARGETNAME configure -event reset-init {
ar9331_25mhz_pll_init
sleep 1
ar9331_ddr2_init
}
set ram_boot_address 0xa0000000
$_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000
flash bank flash0 ath79 0 0 0 0 $_TARGETNAME cs0