tinyriscv-openocd/tcl/target/c100.cfg

66 lines
2.0 KiB
INI
Raw Normal View History

# c100 config
#
#jtag_nsrst_delay 5000
#jtag_ntrst_delay 3000
#reset_config none
reset_config trst_and_srst separate
#reset_config srst_only srst_pulls_trst
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
set _CHIPNAME c100
}
if { [info exists ENDIAN] } {
set _ENDIAN $ENDIAN
} else {
set _ENDIAN little
}
if { [info exists CPUTAPID ] } {
set _CPUTAPID $CPUTAPID
} else {
set _CPUTAPID 0x27b3645b
}
if { [info exists DSPTAPID ] } {
set _DSPTAPID $DSPTAPID
} else {
set _DSPTAPID 0x27b3645b
}
jtag newtap $_CHIPNAME dsp -irlen 5 -ircapture 0x1 -irmask 0x1f -expected-id $_DSPTAPID
# Per ARM: DDI0211J_arm1136_r1p5_trm.pdf - the ARM 1136 as a 5 bit IR register
jtag newtap $_CHIPNAME cpu -irlen 5 -ircapture 0x1 -irmask 0x1f -expected-id $_CPUTAPID
set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME arm11 -endian $_ENDIAN -chain-position $_TARGETNAME
# C100's ARAM 64k SRAM
$_TARGETNAME configure -work-area-phys 0x0a000000 -work-area-size 0x10000 -work-area-backup 0
proc power_restore {} { puts "Sensed power restore. No action." }
proc srst_deasserted {} { puts "Sensed nSRST deasserted. No action." }
# issue telnet: reset init
# issue gdb: monitor reset init
$_TARGETNAME configure -event reset-init {
# Force target into ARM state.
# soft_reset_halt # not implemented on ARM11
puts "Halting C100.CPU"
halt
}
$_TARGETNAME configure -event reset-deassert-post {
# Force target into ARM state.
# soft_reset_halt # not implemented on ARM11
puts "Detected SRSRT asserted on C100.CPU"
}
# Valid events: old-gdb_program_config, old-pre_resume, early-halted, halted, resumed, resume-start, resume-end, gdb-start, gdb-end, reset-start, reset-assert-pre, reset-assert-post, reset-deassert-pre, reset-deassert-post, reset-halt-pre, reset-halt-post, reset-wait-pre, reset-wait-post, reset-init, reset-end, examine-start, examine-end, debug-halted, debug-resumed, gdb-attach, gdb-detach, gdb-flash-write-start, gdb-flash-write-end, gdb-flash-erase-start, gdb-flash-erase-end, resume-start, resume-ok, or resume-end