tinyriscv-openocd/tcl/target/at91sam7sx.cfg

#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config srst_only srst_pulls_trst

if { [info exists CHIPNAME] } {
   set _CHIPNAME $CHIPNAME
} else {
   set _CHIPNAME at91sam7s
}

if { [info exists ENDIAN] } {
   set _ENDIAN $ENDIAN
} else {
   set _ENDIAN little
}

if { [info exists CPUTAPID] } {
   set _CPUTAPID $CPUTAPID
} else {
   set _CPUTAPID 0x3f0f0f0f
}

jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID

set _TARGETNAME $_CHIPNAME.cpu

target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi
$_TARGETNAME configure -event reset-init {
        soft_reset_halt
        # RSTC_CR : Reset peripherals
        mww 0xfffffd00 0xa5000004
        # disable watchdog
	mww 0xfffffd44 0x00008000
	# enable user reset
	mww 0xfffffd08 0xa5000001
	# CKGR_MOR : enable the main oscillator
	mww 0xfffffc20 0x00000601
	sleep 10
	# CKGR_PLLR: 96.1097 MHz
	mww 0xfffffc2c 0x00481c0e
	sleep 10
	# PMC_MCKR : MCK = PLL / 2 ~= 48 MHz
	mww 0xfffffc30 0x00000007
	sleep 10
	# MC_FMR: flash mode (FWS=1,FMCN=73)
	mww 0xffffff60 0x00490100
	sleep 100
}

$_TARGETNAME configure -work-area-phys 0x00200000 -work-area-size 0x4000 -work-area-backup 0

#flash bank <driver> <base_addr> <size> <chip_width> <bus_width> <target_number> [<target_name> <banks> <sectors_per_bank> <pages_per_sector> <page_size> <num_nvmbits> <ext_freq_khz>]
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME at91sam7 0 0 0 0 $_TARGETNAME 0 0 0 0 0 0 0 18432