tinyriscv-openocd/tcl/target/lpc2148.cfg

# Use RCLK. If RCLK is not available fall back to 500kHz.
#
# Depending on cabling you might be able to eek this up to 2000kHz.
jtag_rclk 500

if { [info exists CHIPNAME] } {
   set _CHIPNAME $CHIPNAME
} else {
   set _CHIPNAME lpc2148
}

if { [info exists CPUTAPID ] } {
   set _CPUTAPID $CPUTAPID
} else {
   set _CPUTAPID 0x4f1f0f0f
}

adapter_nsrst_delay 200
jtag_ntrst_delay 200

# NOTE!!! LPCs need reset pulled while RTCK is low. 0 to activate
# JTAG, power-on reset is not enough, i.e. you need to perform a
# reset before being able to talk to the LPC2148, attach is not possible.

reset_config trst_and_srst

jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID

set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME arm7tdmi -chain-position $_TARGETNAME

$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0

$_TARGETNAME configure -event reset-init {
	# Force target into ARM state
	arm core_state arm

	# Do not remap 0x0000-0x0020 to anything but the flash (i.e. select
	# "User Flash Mode" where interrupt vectors are _not_ remapped,
	# and reside in flash instead).
	#
	# See section 7.1 on page 32 ("Memory Mapping control register") in
	# "UM10139: Volume 1: LPC214x User Manual", Rev. 02 -- 25 July 2006.
	# http://www.standardics.nxp.com/support/documents/microcontrollers/pdf/user.manual.lpc2141.lpc2142.lpc2144.lpc2146.lpc2148.pdf
	mwb 0xE01FC040 0x01
}

# flash bank <name> lpc2000 <base> <size> 0 0 <target#> <variant> <clock> [calc checksum]
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME lpc2000 0x0 0x7d000 0 0 $_TARGETNAME lpc2000_v2 14765 calc_checksum