123 lines
4.0 KiB
Plaintext
123 lines
4.0 KiB
Plaintext
/*
|
|
ChibiOS/RT - Copyright (C) 2006,2007,2008,2009,2010 Giovanni Di Sirio.
|
|
|
|
This file is part of ChibiOS/RT.
|
|
|
|
ChibiOS/RT is free software; you can redistribute it and/or modify
|
|
it under the terms of the GNU General Public License as published by
|
|
the Free Software Foundation; either version 3 of the License, or
|
|
(at your option) any later version.
|
|
|
|
ChibiOS/RT is distributed in the hope that it will be useful,
|
|
but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
GNU General Public License for more details.
|
|
|
|
You should have received a copy of the GNU General Public License
|
|
along with this program. If not, see <http://www.gnu.org/licenses/>.
|
|
*/
|
|
|
|
/**
|
|
* @defgroup STM8S STM8S Drivers
|
|
* @details This section describes all the supported drivers on the STM8S
|
|
* platform and the implementation details of the single drivers.
|
|
*
|
|
* @ingroup platforms
|
|
*/
|
|
|
|
/**
|
|
* @defgroup STM8S_HAL STM8S Initialization Support
|
|
* @details The STM8S HAL support is responsible for system initialization.
|
|
*
|
|
* @section stm8s_hal_1 Supported HW resources
|
|
* - CLK.
|
|
* .
|
|
* @section stm8s_hal_2 STM8S HAL driver implementation features
|
|
* - Clock tree initialization.
|
|
* - Clock source selection.
|
|
* .
|
|
* @ingroup STM8S
|
|
*/
|
|
|
|
/**
|
|
* @defgroup STM8S_PAL STM8S PAL Support
|
|
* @details The STM8S PAL driver uses the GPIO peripherals.
|
|
*
|
|
* @section stm8s_pal_1 Supported HW resources
|
|
* - GPIOA.
|
|
* - GPIOB.
|
|
* - GPIOC.
|
|
* - GPIOD.
|
|
* - GPIOE.
|
|
* - GPIOF.
|
|
* - GPIOG (where present).
|
|
* - GPIOH (where present).
|
|
* - GPIOI (where present).
|
|
* .
|
|
* @section stm8s_pal_2 STM8S PAL driver implementation features
|
|
* The PAL driver implementation fully supports the following hardware
|
|
* capabilities:
|
|
* - 8 bits wide ports.
|
|
* - Atomic set/reset/toggle functions because special STM8S instruction set.
|
|
* - Output latched regardless of the pad setting.
|
|
* - Direct read of input pads regardless of the pad setting.
|
|
* .
|
|
* @section stm8s_pal_3 Supported PAL setup modes
|
|
* The STM8S PAL driver supports the following I/O modes:
|
|
* - @p PAL_MODE_RESET.
|
|
* - @p PAL_MODE_UNCONNECTED.
|
|
* - @p PAL_MODE_INPUT.
|
|
* - @p PAL_MODE_INPUT_PULLUP.
|
|
* - @p PAL_MODE_OUTPUT_PUSHPULL.
|
|
* - @p PAL_MODE_OUTPUT_OPENDRAIN.
|
|
* .
|
|
* Any attempt to setup an invalid mode is ignored.
|
|
*
|
|
* @section stm8s_pal_4 Suboptimal behavior
|
|
* The STM8S GPIO is less than optimal in several areas, the limitations
|
|
* should be taken in account while using the PAL driver:
|
|
* - Bus/group writing is not atomic.
|
|
* - Pad/group mode setup is not atomic.
|
|
* .
|
|
* @ingroup STM8S
|
|
*/
|
|
|
|
/**
|
|
* @defgroup STM8S_SERIAL STM8S Serial Support
|
|
* @details The STM8S Serial driver uses the UART peripherals in a
|
|
* buffered, interrupt driven, implementation.
|
|
*
|
|
* @section stm8s_serial_1 Supported HW resources
|
|
* The serial driver can support any of the following hardware resources:
|
|
* - UART1.
|
|
* - UART2 (where present).
|
|
* - UART3 (where present).
|
|
* .
|
|
* @section stm8s_serial_2 STM8S Serial driver implementation features
|
|
* - Clock stop for reduced power usage when the driver is in stop state.
|
|
* - Each UART can be independently enabled and programmed. Unused
|
|
* peripherals are left in low power mode.
|
|
* - Fully interrupt driven.
|
|
* .
|
|
* @ingroup STM8S
|
|
*/
|
|
|
|
/**
|
|
* @defgroup STM8S_SPI STM8S SPI Support
|
|
* @details The SPI driver supports the STM8S SPI peripheral in an interrupt
|
|
* driven implementation.
|
|
* @note Being the SPI a fast peripheral, much care must be taken to
|
|
* not saturate the CPU bandwidth with an excessive IRQ rate. The
|
|
* maximum transfer bit rate is likely limited by the IRQ
|
|
* handling.
|
|
*
|
|
* @section stm8s_spi_1 Supported HW resources
|
|
* - SPI.
|
|
* .
|
|
* @section stm8s_spi_2 STM8S SPI driver implementation features
|
|
* - Clock stop for reduced power usage when the driver is in stop state.
|
|
* - Fully interrupt driven.
|
|
* .
|
|
* @ingroup STM8S
|
|
*/
|