- increased the DMA FIFOs to 64
- added axi slices to the source and destination for DMAs
- for microblaze systems, increade the ad9643 dma data width at destination
- removed sys_fmc_dma_clk and used the sys_200m_clk instead for DMA data transfer
The AXI DMAC controller nativly supports AXI3, there is no need to insert a interconnect to do protocol conversion.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Make sure that the address generator behaves correctly when the buswidth is not
64-bit. Also since the source and destination can have different widths add
separate parameters for source and destination address alignment.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Corrected the ADC/DAC interrupt location for microblaze systems
Removed the ILA clock generation from sys_audio_clkgen and created a
separate clock generator
All system is reset from the same source
The ILA can not work at 250MHz on ZED/ZC702. Because of this, the data
path was modified from 28bits@250MHz to 56bits@125MHz, by using a FIFO.
The ZED/ZC702 max BUFG frequency is 464MHz, which corresponds to a 2.16
period so the constraints were modified accordingly.
ZC702: Removed invalid address segments. Changed the constraints
for adc_clk to minimum possible value in order to meet timing.
ZED: Change the constraints for adc_clk to minimum possible value, in
order to meet timing
AXI_AD9643: Corrected the number of bits in the adc_mon_data bus
Lars-Peter Clausen
Adrian Costina
Istvan Csomortani
Rejeesh Kutty