Clean ran for a project will clean only the project files.
Clean-all ran for a project will clean also the library files on which the project depends.
The clean commands will only remove specific files and directories.
The top Makefile allows several options(per suggestion from jameyhicks):
make fmcomms1.zed will run "make all" in projects/fmcomms1/zed/
make clean will run "make clean" for all the projects
make clean-all will run "make clean" for all the projects and libraries
make lib will run "make all" for the library files
- increased the DMA FIFOs to 64
- added axi slices to the source and destination for DMAs
- for microblaze systems, increade the ad9643 dma data width at destination
- removed sys_fmc_dma_clk and used the sys_200m_clk instead for DMA data transfer
The AXI DMAC controller nativly supports AXI3, there is no need to insert a interconnect to do protocol conversion.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Make sure that the address generator behaves correctly when the buswidth is not
64-bit. Also since the source and destination can have different widths add
separate parameters for source and destination address alignment.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Corrected the ADC/DAC interrupt location for microblaze systems
Removed the ILA clock generation from sys_audio_clkgen and created a
separate clock generator
All system is reset from the same source
The ILA can not work at 250MHz on ZED/ZC702. Because of this, the data
path was modified from 28bits@250MHz to 56bits@125MHz, by using a FIFO.
The ZED/ZC702 max BUFG frequency is 464MHz, which corresponds to a 2.16
period so the constraints were modified accordingly.
ZC702: Removed invalid address segments. Changed the constraints
for adc_clk to minimum possible value in order to meet timing.
ZED: Change the constraints for adc_clk to minimum possible value, in
order to meet timing
AXI_AD9643: Corrected the number of bits in the adc_mon_data bus
Adrian Costina
Rejeesh Kutty
Lars-Peter Clausen
Istvan Csomortani