f0927afd0b
ad9625_fmc: add dma fifo for non-zynq
2014-10-01 14:51:14 -04:00
89964be59e
fmcomms1: Updated project to vivado 2014.2
2014-09-30 10:32:18 +03:00
041d8faaf7
common: Updated common projects for ac701/kc702/zc702/zed to vivado 2014.2
2014-09-30 10:31:00 +03:00
922bc6f03a
fmcadc3: 16bit - but ignored 4 lsb(s)
2014-09-29 15:26:30 -04:00
3c25c1171d
fmcomms1: Fixed missing sample issue on ZC706. Added modifications for all other platforms
2014-09-26 10:28:07 -04:00
87c4c73e22
ad9434: Fix adc_clk constraint
...
ADC clock is 500 Mhz.
2014-09-25 16:54:06 +03:00
82ed885b53
ad9434: Fix SPI line physical constraints
...
SPI lines are not differential.
2014-09-25 16:53:16 +03:00
ccb0b135ca
ad9434: Fix the adc to dma interface.
...
All the device2dma interfaces needs to have a generic form : (data, enable, valid)/channel
2014-09-25 16:50:09 +03:00
683561b67d
AD9434: Initial check in of the library and project with ZC706
2014-09-24 18:27:17 +03:00
1d4bc47cea
ad9265: Initial commit
2014-09-23 22:51:42 -04:00
296983707b
usdrx1: Updated project to 2014.2
2014-09-23 22:45:50 -04:00
5af2474d51
usdrx1: axi_ad9671 / axi_jesd_gt added signal for frame synchronization
2014-09-23 22:44:33 -04:00
bdf01738a1
ultrasound: disconnected ADN4670 chips from SPI lines.
...
Connected everything to ground so that the the clock selected is 0 and all outputs are enabled
2014-09-23 22:30:42 -04:00
7e40f99fe9
fmcomms2: Improved constraints for ac701 and zc702. Fixed common design so that ILA works correctly on microblaze based systems
2014-09-23 22:28:27 -04:00
577441bd0c
daq1: clean up dma interfaces
2014-09-23 14:23:41 -04:00
7c98a783c5
2014.2 updates
2014-09-23 12:32:33 -04:00
1682d9da10
fmcadc3: initial updates
2014-09-22 11:27:17 -04:00
5e3076d770
fmcadc3: daq2 copy
2014-09-22 11:27:16 -04:00
dd7bac41c1
daq1 : Update project to 2014.2
...
- Cores are upadted
- Concat module does not swap output anymore
- Clock signal name ps7_clk_* changed to clk_fpga_*
2014-09-22 17:33:50 +03:00
f2cd7626f5
adi_project : ZC706 board name changed on 2014.2
2014-09-22 17:33:49 +03:00
fb5d212370
daq2/kcu105: fixed timing violations
2014-09-19 15:55:42 -04:00
751bdd6cfc
daq1: Update the constraint file
...
- tx_ref_clk and rx_sysref need to be differential
- cosmetic changes
2014-09-19 18:22:57 +03:00
f43b5d707e
fmcomms2: Reduced clock frequency for ILA to meet timing for ZED
...
Modified ZED constraints to 250 MHz for the clock from AD9361
2014-09-16 16:08:28 -04:00
d33fb07587
usdrx1: Modified the GPIO assignments so that board specific GPIOs start from GPIO 32.
...
GPIOs for which the directions is known, have been specifically assigned.
The SPI clock has been changed to a lower frequency.
2014-09-16 15:56:19 -04:00
d4db53c3b0
usdrx1_spi: Modified module to be compatible with altera
2014-09-16 15:53:11 -04:00
a3dbd5ac00
projects/common/vc707/vc707_system_bd: AD9625_FMC update to 2014.2
...
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
2014-09-16 14:59:36 +02:00
a91f4bb6b9
daq1: General updates
...
- Add additional GT setups
- Use channel PLL instead of quad PLL
- Add additional ILA probes for debug
2014-09-13 00:23:11 +03:00
d8651cdd2e
fmcomms2: c5soc: Set dac_util_unpack number of channels to 4
...
We only do have 4 channels in this design. Reducing the number of supported
channels for the dac_util_unpack core to 4 from 8 lowers the DMA alignment
requirement from 128bit to 64bit. We need this since applications only
expect a DMA alignment requirement of 64bit.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2014-09-12 16:15:12 +02:00
ecc498313c
fmcomms2: c5soc: Connect ADC, DAC and VGA DMA to different bridge interconnects
...
We have enough bridge interconnect to give each DMA its own, so use them.
This makes sure that they do not interfere with each others transfers to
much. The SDRAM controller side of the FPGA2SDRAM bridges FIFO runs at a
much faster frequency then what we are able to use in the fabric. So its
better to do the arbitration on that side of the bus to make sure that we
can utilize the buses in the FPGA fabric to the maximum for each DMA core.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2014-09-12 16:14:07 +02:00
61f21a17b3
fmcomms2:c5soc project upgraded with util_dac_unpack
2014-09-11 15:13:09 -04:00
4c1c50788e
fmcomms5: c5soc: Fix typo
...
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2014-09-11 17:15:10 +02:00
41cc92ef49
Remove BASEADDR/HIGHADDR parameters
...
This is unused and unneeded. The AXI interconnect will make sure that a
peripheral only gets requests that are meant for it, there is no need to
check the address in the peripheral itself.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2014-09-11 12:26:37 +02:00
647a26e19c
projects/common/vc707/vc707_system_bd.tcl: Select Linux MMU settings
2014-09-10 17:40:36 +02:00
c7989925c5
fmcomms2: c5soc: Add false path between 50MHz and VGA PLL clock
...
Otherwise we get timing errors for the reset signal that is generated in the
50MHz clock domain, but used in the VGA PLL clock domain.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2014-09-09 15:05:06 +02:00
328205c31d
fmcomms2: c5soc: Set DMA transfer length to 24 bits
...
14 bits is a bit to low and we use 24 bits everywhere else as well.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2014-09-09 15:05:06 +02:00
50faf0c53a
Remove executable flags from non-exectuable files
2014-09-09 15:05:06 +02:00
b58e425b44
daq2/kcu105: timing improvement -register slices hang
2014-09-08 10:24:56 -04:00
6e389b8c47
motor_control: Updated the FOC IP and the encoder connections to the IP
2014-09-06 15:58:03 +03:00
669462e0f6
ad9625x2: updates on pcores
2014-09-05 12:25:43 -04:00
72f31370ef
a5gt: ethernet-fpga lvds mode
2014-09-04 11:19:25 -04:00
3deb55bb98
a5gt: ethernet i/o changed to lvds
2014-09-04 11:19:24 -04:00
dfb94f7b68
motor_control: Modified foc_controller to be compatible with other cores
2014-09-03 12:09:37 +03:00
9f3461b130
fmcjesdadc1: Added support for KC705
2014-09-02 18:02:25 +03:00
17122661d2
fmcomms2_pr: Fix file path on ZC706/system_bd.tcl
2014-09-01 18:49:55 +03:00
2ce7695bf7
fmcjesdadc1: Initial commit of VC707 version
2014-09-01 18:47:01 +03:00
9a80fec4e4
fmcjesdadc1: Delete trailing whitespaces
2014-09-01 18:45:20 +03:00
d08d0cd70b
motor_control: added the MW FOC IP and updated the design
2014-09-01 18:35:21 +03:00
ee752ec08a
daq1: Initial commit
2014-09-01 18:34:31 +03:00
a773cc4992
usdrx1: updated project
...
ad_jesd_align wasa updated to be able to work with frames that have more than 4 octets per frame
2014-09-01 15:18:39 +03:00
95c143412d
fmcomms2: Modified design to work with 4 channel util_adc_pack
2014-08-29 13:53:59 +03:00
Rejeesh Kutty
Adrian Costina
Istvan Csomortani
Michael Hennerich
Lars-Peter Clausen
acozma